Show Dhcpsnooping Binding - Enterasys C3G124-24 Configuration Manual

Example
This example shows the output of the show dhcpsnooping port command.
C3(su)->show dhcpsnooping port ge.1.1
Interface
----------
ge.1.1

show dhcpsnooping binding

Use this command to display the contents of the DHCP snooping bindings database.
Syntax
show dhcpsnooping binding [dynamic | static] [port port-string] [vlan vlan-id]
Parameters
dynamic | static
port port-string
vlan vlan-id
Defaults
If no parameters are entered, all bindings in the database are displayed.
Mode
Switch command, read-write.
Usage
This command displays information about the DHCP bindings in the DHCP snooping database.
Example
This example shows the output of the show dhcpsnooping binding command when no
parameters are entered.
C3(su)->show dhcpsnooping binding
Total number of bindings:
MAC Address
-----------------
00:02:B3:06:60:80
00:0F:FE:00:13:04
Trust State Rate Limit
------------- -------------
No
(Optional) Limits the display of bindings in the database by type of
entry, either dynamic or static.
(Optional) Limits the display of bindings in the database by port.
(Optional) Limits the display of bindings in the database by VLAN id.
2
IP Address
---------------
192.168.10.10
192.168.20.1
Burst Interval
(pps) (seconds)
---------------
20
VLAN Interface
---- -----------
3 ge.1.1
5 ge.1.30
show dhcpsnooping binding
2
Type Lease (min)
------- -----------
STATIC
DYNAMIC 1440
Enterasys C3 Configuration Guide 23-11