Enterasys C3G124-24 Configuration Manual page 885

Table 32-8 show pwa Output Details (Continued)
Output Field
PWA Logo
PWA Guest
Networking Status
PWA Guest Name
PWA Guest
Password
PWA Redirect Time
Port
Mode
Auth Status
Quiet Period
MaxReq
set pwa
Use this command to enable or disable port web authentication.
Syntax
set pwa {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to enable port web authentication:
C3(su)->set pwa enable
What It Displays...
Whether the Enterasys logo will be displayed or hidden at user login. Default state of
enabled (displayed) can be changed using the set pwa displaylogo command as
described in "set pwa displaylogo" on page 32-81.
Whether PWA guest user status is disabled or enabled with RADIUS or no
authentication. Default state of disabled can be changed using the set pwa
gueststatus command as described in
Guest user name for PWA enhanced mode networking. Default value of "guest" can
be changed using the set pwa guestname command as described in
guestname" on page 32-83.
Guest user's password. Default value of an empty string can be changed using the
set pwa guestpassword command as described in
page 32-84.
Time in seconds after login success before the user is redirected to the PWA home
page.
PWA port designation.
Whether PWA is enabled or disabled on his port.
Whether or not the port state is disconnected, authenticating, authenticated, or held
(authentication has failed).
Amount of time a port will be in the held state after a user unsuccessfully attempts to
log on to the network. Default value of 60 can be changed using the set pwa
quietperiod command as described in
Maximum number of log on attempts allowed before transitioning the port to a held
state. Default value of 2 can be changed using the set pwa maxrequests command
as described in "set pwa maxrequest" on page 32-86.
Enables or disables port web authentication.
"set pwa gueststatus" on page 32-84.
"set pwa guestpassword" on
"set pwa quietperiod" on page 32-85.
Enterasys C3 Configuration Guide 32-79
set pwa
"set pwa