Show Ip Ospf - Enterasys C3G124-24 Configuration Manual

show ip ospf

Defaults
If metric value is not specified, 0 will be applied.
If type value is not specified, type 2 (external route) will be applied.
If subnets is not specified, only the shortest prefix matching routes will be redistributed.
Mode
Router configuration: C3(su)->router(Config-router)#
Example
This example shows how to redistribute RIP routing information to non-subnetted routes in OSPF
routes:
C3(su)->router(Config)#router ospf
C3(su)->router(Config-router)#redistribute rip
show ip ospf
Use this command to display OSPF information.
Syntax
show ip ospf
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display OSPF information:
C3(su)->router#show ip ospf
Routing process "ospf 1" with ID 155.155.155.155
Supports only Normal TOS route.
It is not an area border router and is an autonomous system boundary router.
Redistributing External Routes from static
Number of areas in this router is 2
Area 0.0.0.0
SPF algorithm executed 0 times
Area ranges are
Link State Age Interval is 10
Area 0.0.0.8
SPF algorithm executed 302 times
Area ranges are
Link State Age Interval is 10
27-18 IPv4 Advanced Routing Protocol Configuration