Clear Banner - Enterasys C3G124-24 Configuration Manual

clear banner

Defaults
None.
Mode
Switch command, read-write
Usage
A login banner is displayed prior to session login. When configured, a login banner will cause a
prompt to display which requires the user to verify y/n before the login will continue. These
acknowledgements are recoded in the audit log in association with the user's login name.
For example, if the login banner is configured as "By proceeding with this login you are verifying
that you are an Enterasys employee and authorized to use this system.", the following will display
prior to entering the login password:
By proceeding with this login you are verifying that you are an Enterasys
employee and authorized to use this system.
Proceed to login? (y/n) [n]?
For SSH sessions which do not allow for an acceptance prompt, the following message will be
added after the banner display and before the login prompt:
Entering a password constitutes your understanding of, and compliance with,the
preceding banner message.
A message of the day banner is displayed after session login.
Banner message text must be enclosed in beginning and ending double quotation marks. The
message itself cannot contain any additional double quotation marks. Use the \? Escape sequence
when ending a banner with a question mark to avoid the question mark being treated as a help
request.
Example
This example shows how to set the message of the day banner to read: "This system belongs to
XYZ Corporation. Use of this system is strictly limited to authorized personnel."
C3(rw)->set banner motd "\tThis system belongs to XYZ Corporation.\nUse of this
system is strictly limited to authorized personnel."
clear banner
Use this command to clear the login banner or message of the day banner. to a blank string.
Syntax
clear banner {login | motd}
Parameters
login
motd
Defaults
None.
3-20 Basic Configuration
Specifies that the pre-session login message should be cleared.
Specifies that the message of the day banner should be cleared.