Ip Ospf Enable - Enterasys C3G124-24 Configuration Manual

Defaults
None.
Mode
Router configuration: C3(su)->router(Config-router)#
Usage
The fixed switch firmware also provides this command to implement RFC 1583 compatibility. RFC
1583 used a method to calculate metrics for summary routes that is different from the method
specified in RFC 2328. In order to avoid the problem of sub-optimal routing in networks where not
all routers have been upgraded to RFC 2328 implementations, you can make OSPF compatible
with RFC 1583 with this command.
Example
This example shows how to enable RFC 1583 compatibility:
C3(su)->router(Config)#router ospf 1
C3(su)->router(Config-router)#1583compatability

ip ospf enable

Use this command to enable OSPF on an interface. The no form of this command disables OSPF on
an interface.
Syntax
ip ospf enable
no ip ospf enable
Parameters
None.
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to enable OSPF on the VLAN 1 interface:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip ospf enable
(su)->router(Config-if(Vlan 1))#
ip ospf enable
Enterasys C3 Configuration Guide 27-5