Using Dhcp/Bootp; Figure 3-7. Ip Configuration - Enterasys Matrix-V V2H124-24 Configuration Manual

Matrix v-series fast ethernet switch
Hide thumbs Also See for Matrix-V V2H124-24:
Table of Contents

Advertisement

3
Configuring the Switch

Using DHCP/BOOTP

If your network provides DHCP/BOOTP services, you can configure the switch to be
dynamically configured by these services.
Web –
Click System, IP Configuration. Specify the VLAN to which the management
station is attached, set the IP Address Mode to DHCP or BOOTP. Click Apply to
save your changes. Then click Restart DHCP to immediately request a new
address. Note that the switch will also broadcast a request for IP configuration
settings on each power reset
Note: If you lose your management connection, use a console connection and enter
"show ip interface" to determine the new switch address.
CLI – Specify the management interface, and set the IP Address Mode to DHCP or
BOOTP.
Console#config
Console(config)#interface vlan 1
Console(config-if)#ip address dhcp
Console(config-if)#end
Console#ip dhcp restart
Console#show ip interface
IP address and netmask: 192.168.1.54 255.255.255.0 on VLAN 1,
and address mode:
Console#
3-16
.

Figure 3-7. IP Configuration

User specified.
4-151
4-234
4-235
4-236

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Matrix-v v2h124-24fxMatrix-v v2h124-24p

Table of Contents