Overview; Default Conditions - Enterasys C3G124-24 Configuration Manual

Overview

autoconfiguration is part of Router Advertisement and the Enterasys C3 can support both stateless
and stateful autoconfiguration of end nodes. The Enterasys C3 supports both EUI-64 interface
identifiers and manually configured interface IDs.
Refer to the following RFCs for more information about Neighbor Discovery and stateless address
autoconfiguration:
• RFC 4861, "Neighbor Discovery for IP Version 6"
• RFC 4862, "IPv6 Stateless Address Autoconfiguration"
For ICMPv6, error PDU generation is supported, as are path MTU, echo, and redirect.
Router Advertisement is an integral part of IPv6 and is supported. Numerous options are
available including stateless/stateful address configuration, router and address lifetimes, and
Neighbor Discovery timer control. Ping and traceroute applications for IPv6 are provided.
Management of IPv6 features is provided by means of CLI commands and SNMP. See
IPv6 Management

Default Conditions

The following table lists the default IPv6 conditions.
Condition
IPv6 forwarding
IPv6 route distance
IPv6 maximum hop limit
IPv6 unicast-routing
IPv6 enable
IPv6 mtu
IPv6 nd dad attempts
IPv6 nd managed-config-flag
IPv6 nd ns-interval
IPv6 nd other-config-flag
IPv6 nd ra-interval
IPv6 nd ra-lifetime
IPv6 nd reachable-time
IPv6 nd suppress-ra
IPv6 nd prefix
29-2 IPv6 Configuration
for descriptions of the CLI commands.
Default Value
Enabled
1
64
Disabled
Disabled
1500
1
False
0
False
600
1800
0
Disabled
Valid-lifetime — 604800
Preferred-lifetime — 2592000
Autoconfig — enabled
On-link — enabled
Chapter 28,