Enterasys C3G124-24 Configuration Manual page 411

The following parameters apply to creating a traffic classification rule.
profile-index
ether
ipproto
ipdestsocket
ipsourcesocket
iptos
macdest
macsource
tcpdestport
tcpsourceport
udpdestport
udpsourceport
data
mask mask
vlan vlan
cos cos
drop | forward
Defaults
None.
Mode
Switch command, read-write.
Specifies a policy profile number to which this rule will be assigned.
Policy profiles are configured with the set policy profile command as
described in "set policy
are 1- 255.
Specifies that the rule should apply to traffic with the specified type field
in Ethernet II packet.
Specifies that the rule should apply to traffic with the specified Protocol
field in IP packet.
Specifies that the rule should apply to traffic with the specified
destination IP address with optional post-fixed TCP or UDP port.
Specifies that the rule should apply to traffic with the specified source IP
address, with optional post-fixed TCP or UDP port.
Specifies that the rule should apply to traffic with the specified Type of
Service field in IP packet.
Specifies that the rule should apply to traffic with the specified MAC
destination address.
Specifies that the rule should apply to traffic with the specified MAC
source address.
Specifies that the rule should apply to traffic with the specified TCP
destination port.
Specifies that the rule should apply to traffic with the specified TCP
source port.
Specifies that the rule should apply to traffic with the specified UDP
destination port.
Specifies that the rule should apply to traffic with the specified UDP
source port.
Specifies the code for the specified traffic classifier (listed above). This
value is dependent on the classification type entered. Refer to
for valid values for each classification type.
(Optional) Specifies the number of significant bits to match, dependent on
the data value entered. Refer to
classification type and data value.
Specifies the action of the rule is to classify to a VLAN ID.
Specifies the action of the rule is to classify to a Class-of-Service ID. Valid
values are 0 - 4095. A value of -1 indicates that no CoS forwarding
behavior modification is desired.
Specifies that packets within this classification will be dropped or
forwarded.
profile" on page 15-3. Valid profile-index values
Table 15-3 for valid values for each
Enterasys C3 Configuration Guide 15-11
set policy rule
Table 15-3