Parameters
connected | static
metric value
metric-type type
tag tag
Defaults
The default values are:
Metric = unspecified
Metric type = Type 2
Tag = 0
Mode
Router OSPFv3 configuration: C3(su)->router(Config-router)#
Usage
The no form of this command configures the OSPFv3 protocol to prohibit redistribution of routes
from the specified source protocol/routers.
Example
This example configures route redistribution of static routes and applies a metric of 10
C3(su)->router(Config-router)# redistribute static metric 10
passive-interface
Use this command to enable passive OSPF on an interface or to set passive OSPF as the default
mode.
Syntax
passive-interface {default | vlan vlan-id}
no passive-interface {default | vlan vlan-id}
Parameters
default
vlan vlan-id
Defaults
None.
Specifies the source protocol to redistribute.
(Optional) Specifies the route redistribution metric. The metric value can
range from 0 to 16777214.
(Optional) Specifies the route redistribution metric type. The metric type
can be 1, which specifies type 1 external route, or 2, which specifies type
2 external route.
(Optional) Specifies a route redistribution tag. The value of tag can
range from 0 to4294967295.
Configure the default mode of operation for all interfaces.
Specifies the interface on which to enable passive OSPF mode.
passive-interface
Enterasys C3 Configuration Guide 31-9