Area Configuration Commands; Purpose; Commands - Enterasys C3G124-24 Configuration Manual

Area Configuration Commands

Mode
Router configuration: C3(su)->router(Config-router)#
Usage
Passive mode allows an interface to be included in the OSPF route table, but turns off sending and
receiving hellos for the interface. It also prevents OSPF adjacencies from being formed on an
interface.
The no form of this command disables passive OSPF mode.
Examples
This example enables passive OSPF mode on VLAN 102.
C3(su)->router(Config)#ipv6 router ospf
C3(su)->router(Config-router)#passive-interface vlan 102
This example shows how to make passive OSPF mode the default mode on all interfaces.
C3(su)->router(config#ipv6 router ospf
C3(su)->router(Config-router)#passive-interface default
Area Configuration Commands

Purpose

These commands are used to configure area parameters.

Commands

For information about...
area default-cost
area nssa
area nssa default-info-originate
area nssa no-redistribute
area nssa no-summary
area nssa translator role
area nssa translator-stab-intv
area range
area stub
area stub no-summary
area virtual-link
area virtual-link dead-interval
area virtual-link hello-interval
area virtual-link retransmit-interval
area virtual-link transmit-delay
31-10 OSPFv3 Configuration
Refer to page...
31-11
31-11
31-12
31-13
31-13
31-14
31-15
31-15
31-16
31-17
31-18
31-18
31-19
31-20
31-20