Set Linkflap Globalstate; Set Linkflap Portstate; Show Linkflap Metrics Output Details - Enterasys C3G124-24 Configuration Manual

Table 11-5 show linkflap metrics Output Details
Output Field
Port
LinkStatus
CurrentCount
TotalCount
TimeElapsed
Violations

set linkflap globalstate

Use this command to globally enable or disable the link flap detection function.
Syntax
set linkflap globalstate {disable | enable}
Parameters
disable | enable
Defaults
By default, the function is disabled globally and on all ports.
Mode
Switch mode, read-write.
Usage
By default, the function is disabled globally and on all ports. If disabled globally after per-port
settings have been configured using the linkflap commands, per-port settings will be retained.
Example
This example shows how to globally enable the link trap detection function.
C3(rw)->set linkflap globalstate enable

set linkflap portstate

Use this command to enable or disable link flap monitoring on one or more ports.
Syntax
set linkflap portstate {disable | enable} [port-string]
What it displays...
Port designation.
Link status according to the link flap function.
Link down count accruing toward the link flap threshold.
Number of link downs since system start,
Time (in seconds) since the last link down event.
Number of link flap violations on listed ports since system start.
Globally disables or enables the link flap detection function.
set linkflap globalstate
Enterasys C3 Configuration Guide 11-27