Show Eapol - Enterasys C3G124-24 Configuration Manual

This example shows how to reset the 802.1X quiet period to 60 seconds on ports ge.1.1-3:
C3(su)->clear dot1x auth-config quietperiod ge.1.1-3

show eapol

Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
port-string
Defaults
If port-string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display EAPOL status for ports
C3(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port
--------
ge.1.1
ge.1.2
ge.1.3
Table 32-2
command to enable the protocol and assign an authentication mode, refer to
page 32-27.
(Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port-string values, refer to
in the CLI" on page 11-1.
Authentication State
--------------------
Initialize
Initialize
Initialize
provides an explanation of the command output. For details on using the set eapol
.1.1-3:
ge
Authentication Mode
--------------------
Auto
Auto
Auto
Enterasys C3 Configuration Guide 32-25
show eapol
"Port String Syntax Used
"set eapol" on