Show Tacacs Interface; Set Tacacs Interface - Enterasys C3G124-24 Configuration Manual

Defaults
None.
Mode
Switch command, Read-Write.
Examples
This example shows how to disable sending multiple requests over a single connection.
C3(rw)->set tacacs singleconnect disable

show tacacs interface

Use this command to display the interface used for the source IP address of the TACACS+ packets
generated by the switch.
Syntax
show tacacs interface
Parameters
None.
Defaults
None.
Mode
Switch mode, read-only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the TACACS+ packets generated by
the switch.
C3(rw)->show tacacs interface
loopback 1

set tacacs interface

Use this command to specify the interface used for the source IP address of the TACACS+ packets
generated by the switch.
Syntax
set tacacs interface {loopback loop-ID | vlan vlan-ID}
Parameters
loopback loop-ID
192.168.10.1
Specifies the loopback interface to be used. The value of loop-ID can
range from 0 to 7.
show tacacs interface
Enterasys C3 Configuration Guide 36-11