Clear Arpinspection Filter - Enterasys C3G124-24 Configuration Manual

Usage
You can use this command to disable dynamic ARP inspection on one or more VLANs, or you can
disable logging of invalid ARP packets on specified VLANs. To disable both logging and DAI, you
must enter this command twice.
Example
This example first displays the DAI configuration for VLAN 5, then disables DAI on VLAN 5, then
disables logging of invalid ARP packets on VLAN 5.
C3(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
C3(su)->clear arpinspection vlan 5
C3(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
C3(su)->clear arpinspection vlan 5 logging
C3(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5

clear arpinspection filter

Use this command to remove an ARP ACL from a VLAN or from the switch, or to remove a
permit rule from an existing ACL, or to change the status of static mapping to disabled.
Syntax
clear arpinspection filter name [permit ip host sender-ipaddr mac host
sender-macaddr] | [vlan vlan-range [static]
Parameters
name
permit
Configuration Log Invalid
------------- ----------- --------------------------------
Enabled Enabled
Configuration Log Invalid
------------- ----------- --------------------------------
Disabled Enabled
Configuration Log Invalid
------------- ----------- --------------------------------
Disabled Disabled
Specifies the name of the ARP ACL.
(Optional) Specifies that a permit rule is being deleted.
Disabled
Disabled
Disabled
ACL Name
staticARP
Disabled
Disabled
Disabled
ACL Name
staticARP
Disabled
Disabled
Disabled
ACL Name
staticARP
Enterasys C3 Configuration Guide 23-27
clear arpinspection filter
Static flag
-----------
Enabled
Static flag
-----------
Enabled
Static flag
-----------
Enabled