Set Sntp Interface - Enterasys C3G124-24 Configuration Manual

set sntp interface

set sntp interface
Use this command to specify the interface used for the source IP address of the SNTP client.
Syntax
set sntp interface {loopback loop-ID | vlan vlan-ID}
Parameters
loopback loop-ID
vlan vlan-ID
Defaults
None.
Mode
Switch command, read-write.
Usage
This command allows you to configure the source IP address used by the SNTP application when
generating packets for management purposes. Any of the management interfaces, including
VLAN routing interfaces, can be configured as the source IP address used in packets generated by
the SNTP client.
An interface must have an IP address assigned to it before it can be set by this command.
If no interface is specified, then the IP address of the Host interface will be used.
If a non-loopback interface is configured with this command, application packet egress is
restricted to that interface if the server can be reached from that interface. Otherwise, the packets
are transmitted over the first available route. Packets from the application server are received on
the configured interface.
If a loopback interface is configured, and there are multiple paths to the application server, the
outgoing interface (gateway) is determined based on the best route lookup. Packets from the
application server are then received on the sending interface. If route redundancy is required,
therefore, a loopback interface should be configured.
Example
This example configures an IP address on VLAN interface 100 and then sets that interface as the
SNTP client source IP address.
C3(rw)->router(Config-if(Vlan 100))#ip address 192.168.10.1 255.255.255.0
C3(rw)->router(Config-if(Vlan 100))#exit
C3(rw)->router(Config)#exit
C3(rw)->router#exit
C3(rw)->router>exit
C3(rw)->set sntp interface vlan 100
C3(rw)->show sntp interface
Specifies the loopback interface to be used. The value of loop-ID can
range from 0 to 7.
Specifies the VLAN interface to be used. The value of vlan-ID can range
from 1 to 4093.
Configuring SNTP
Enterasys C3 Configuration Guide 20-11