Show Ipv6 Ospf Database - Enterasys C3G124-24 Configuration Manual

show ipv6 ospf database

This command displays information about the link state database when OSPFv3 is enabled.
Syntax
show ipv6 ospf [areaid] database [{external | inter-area {prefix | router} | link |
network | nssa-external | prefix | router | unknown {area | as | link}}]
[lsid] [{adv-router [rtrid] | self-originate | database-summary}]
Parameters
areaid
external
inter-area
prefix
router
link
network
nssa-external
unknown
{area | as | link}
lsid
adv-router [rtrid]
self-originate
database-summary
Defaults
If no parameters are entered, LSA headers for all areas are displayed.
Mode
Router privileged execution: C3(su)->router#
Usage
If you execute this command without any parameters, LSA headers for all areas are displayed. Use
the areaid parameter to display database information for a specific area. The other optional
parameters can be used to specify a particular type of link state advertisement to display.
Examples
This example displays the output when an area ID is specified.
C3(su)->router#show ipv6 ospf 10 database
(Optional) Display database information about a specific area. Enter the
area ID in IP address format (dotted-quad) or as a decimal value.
(Optional) Display external LSAs.
(Optional) Display inter-area LSAs.
(Optional) Display intra-area Prefix LSAs.
(Optional) Display router LSAs.
(Optional) Display link LSAs.
(Optional) Display network LSAs.
(Optional) Display NSSA external LSAs.
(Optional) Display unknown area, unknown AS, or unknown link
LSAs.
(Optional) Specifies the link state ID.
(Optional) Display the LSAs that are restricted by the advertising router.
Optionally, specify the router by its router ID (rtrid), entered as a 32-bit
dotted-quad value.
(Optional) Display LSAs that are self-originated.
(Optional) Displays the number of each type of LSA in the database and
the total number of LSAs in the database.
Inter Network States (Area 0.0.0.10)
show ipv6 ospf database
Enterasys C3 Configuration Guide 31-35