Interface - Enterasys C3G124-24 Configuration Manual

interface

Use this command to configure interfaces for IP routing.
Syntax
interface vlan vlan-id | loopback loop-id
Parameters
vlan vlan-id
loopback loop-id
Defaults
None.
Mode
Router global configuration mode: C3(su)->router(Config)#
Usage
This command enables interface configuration mode from global configuration mode, and, if the
interface has not previously been created, this command creates a new routing interface. For
details on configuration modes supported by the Enterasys C3 device and their uses, refer to
Table 24-2
VLANs must be created from the switch CLI before they can be configured for IP routing. For
details on creating VLANs and configuring them for IP, refer to
Modes" on page 24-2.
Each VLAN interface must be configured for routing separately using the interface command. To
end configuration on one interface before configuring another, type exit at the command prompt.
Enabling interface configuration mode is required for completing interface-specific configuration
tasks. For an example of how these commands are used, refer to
Tasks" on page 24-1.
A loopback interface is always expected to be up. This interface can provide the source address for
sent packets and can receive both local and remote packets. The loopback interface is typically
used by routing protocols, but it can also be used for management or network services such as
RADIUS, SNMP, Syslog, SNTP, or sFlow. By default, if RADIUS is configured with no host IP
address on the device, it will use the loopback interface 0 IP address (if it has been configured) as
its source for the NAS-IP attribute. (Administrators can assign where to source management or
network service IP packets via the set interface commands.)
Each Enterasys C3 system (stack) can support up to 24 routing interfaces. Each interface can be
configured for the RIP and/or OSPF routing protocols.
Specifies the number of the VLAN interface to be configured for routing.
This interface must be configured for IP routing as described in
Routing Configuration
Specifies the number of the loopback interface to be configured for routing.
The value of loop-id can range from 0 to 7.
in "Enabling Router Configuration
Note: For information about configuring tunnel interfaces, see
page 25-8.
Tasks" on page 24-1.
Modes" on page 24-2.
"Enabling Router Configuration
"Pre-Routing Configuration
"Configuring Tunnel
Enterasys C3 Configuration Guide 25-3
interface
"Pre-
Interfaces" on