Show Tacacs Singleconnect; Set Tacacs Singleconnect - Enterasys C3G124-24 Configuration Manual

show tacacs singleconnect

When per-command accounting is enabled, the TACACS+ server will log accounting information,
such as start and stop times, IP address of the client, and so forth, for each command executed
during the session.
When per-command authorization is enabled, the TACACS+ server will check whether each
command is permitted for that authorized session and return a success or fail. If the authorization
fails, the command is not executed.
Example
This example shows how to enable TACACS+ authorization on a command basis.
C3(rw)->set tacacs command authorization enable
show tacacs singleconnect
Use this command to display the current status of the TACACS+ client's ability to send multiple
requests over a single TCP connection.
Syntax
show tacacs singleconnect
Parameters
None.
Defaults
None.
Mode
Switch command, Read-Write.
Example
This example shows how to display the state of the TACACS+ client's ability to send multiple
requests over a single connection.
C3(rw)->show tacacs singleconnect
TACACS+ single-connect state:

set tacacs singleconnect

Use this command to enable or disable the ability of the TACACS+ client to send multiple requests
over a single TCP connection. When enabled, the TACACS+ client will use a single TCP
connection for all requests to a given TACACS+ server.
Syntax
set tacacs singleconnect {enable | disable}
Parameters
enable | disable
36-10 TACACS+ Configuration
enabled
Enable or disable the ability to send multiple requests over a single TCP
connection.