Set System Name; Set System Location - Enterasys C3G124-24 Configuration Manual

set system name

Table 3-4 show version Output Details (Continued)
Output Field
Serial #
Versions
set system name
Use this command to configure a name for the system.
Syntax
set system name [string]
Parameters
string
Defaults
If string is not specified, the system name will be cleared.
Mode
Switch command, read-write.
Example
This example shows how to set the system name to Information Systems:
C3(su)->set system name "Information Systems"

set system location

Use this command to identify the location of the system.
Syntax
set system location [string]
Parameters
string
3-22 Basic Configuration
What It Displays...
Serial number of the switch.
• Hw: Hardware version number.
• Bp: BootPROM version.
• Fw: Current firmware version number.
• BuFw: Backup firmware version number.
• PoE: Power over Ethernet driver version. (Displays only for PoE switches.)
(Optional) Specifies a text string that identifies the system.
Note: A name string containing a space in the text must be enclosed in quotes as
shown in the example below.
(Optional) Specifies a text string that indicates where the system is
located.
Note: A location string containing a space in the text must be enclosed in quotes
as shown in the example below.