Configuring General Dhcp Server Parameters; Purpose; Commands - Enterasys C3G124-24 Configuration Manual

Stackable switches

Hide thumbs Also See for C3G124-24:

Release note (41 pages)

Quick reference (2 pages)

Datasheet (9 pages)

page of 954

/ 954
Contents
Table of Contents
Bookmarks

Table of Contents

Create a routed interface for the VLAN in router configuration mode. In the following

example, an IP address is associated with routed interface VLAN 6:

In router configuration mode:

interface vlan 6

ip address 6.6.1.1 255.255.0.0

Enable DHCP server functionality on the system with the set dhcp enable command.

Create the DHCP address pool. The only required steps are to name the pool and define the

network number and mask for the pool. Note that the pool has to be in the same subnet as the

routed interface and use the same mask configured on the routed interface. For example:

set dhcp pool auto-pool network 6.6.0.0 255.255.0.0

DHCP clients in VLAN 6 will be served IP addresses from this DHCP address pool.

Optional DHCP server tasks include:

You can limit the scope of addresses assigned to a pool for dynamic address assignment with

the set dhcp exclude command. Up to 128 non-overlapping address ranges can be excluded

on the Enterasys C3. For example:

set dhcp exclude 192.0.0.1 192.0.0.10

Configure static address pools for manual address assignment. The only required steps are to

name the pool, configure either the hardware address of the client or the client identifier, and

configure the IP address and mask for the manual binding. For example:

set dhcp pool static-pool hardware-address 0011.2233.4455

set dhcp pool static-pool host 192.0.0.200 255.255.255.0

Set other DHCP server parameters such as the number of ping packets to be sent before

assigning an IP address, or enabling conflict logging.