Reviewing Port Status; Purpose; Commands; Show Port - Enterasys C3G124-24 Configuration Manual

Reviewing Port Status

Where port number depends on the device. The highest valid port number is dependent on the
number of ports in the device and the port type.
Port Slot/Unit Parameters Used in the CLI
The "unit" parameter is often used interchangeably with "module" in the standalone switch CLI
to indicate a module slot location.
Examples
unit This example shows the port-string syntax for specifying the 1-Gigabit Ethernet port 14 in
.
unit 3
ge.3.14
This example shows the port-string syntax for specifying all 1-Gigabit Ethernet ports in unit 3 in
the system.
ge.3.*
This example shows the port-string syntax for specifying all ports (of any interface type) in the
system.
*.*.*
Reviewing Port Status

Purpose

To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.

Commands

For information about...

show port

show port status
show port counters
clear port counters
show port cablestatus
show port
Use this command to display whether or not one or more ports are enabled for switching.
Syntax
show port [port-string]
11-2 Port Configuration
Note: You can use a wildcard (*) to indicate all of an item. For example, fe.3.* would represent all
100Mbps Ethernet (fe) ports in unit 3, and ge.3 * would represent all 1-Gigabit Ethernet (ge) ports
in unit 3.
Refer to page...
11-2
11-3
11-4
11-5
11-6