Area Default-Cost; Area Nssa - Enterasys C3G124-24 Configuration Manual

area default-cost

This command configures the default cost for the summary default route generated by the area
border router into the stub or NSSA area.
Syntax
area areaid default-cost cost
no area areaid default-cost
Parameters
areaid
cost
Defaults
None.
Mode
Router OSPFv3 configuration: C3
Usage
Use this command to set the cost value for the default route that is sent into a stub area or NSSA
by an Area Border Router (ABR). The no form of this command removes the cost value from the
summary route that is sent into the stub area.
Example
This example sets the default route cost to 50 for area 20.
C3(su)->router(Config-router)# area 20 default-cost 50

area nssa

This command configures the specified area to function as a not so stubby area (NSSA).
Syntax
area areaid nssa
no area areaid nssa
Parameters
areaid
Defaults
None.
Mode
Router OSPFv3 configuration: C3(su)->router(Config-router)#
Specifies the area ID in IP address format (dotted-quad) or as a decimal
value.
Specifies a cost, which can range between 1 and 16777215.
(su)->router(Config-router)#
Specifies the area ID in IP address format (dotted-quad) or as a decimal
value.
area default-cost
Enterasys C3 Configuration Guide 31-11