Configuring Mac Authentication; Purpose; Commands; Show Macauthentication - Enterasys C3G124-24 Configuration Manual

Configuring MAC Authentication

Purpose

To review, disable, enable and configure MAC authentication. This authentication method allows
the device to authenticate source MAC addresses in an exchange with an authentication server.
The authenticator (switch) selects a source MAC seen on a MAC-authentication enabled port and
submits it to a backend client for authentication. The backend client uses the MAC address stored
password, if required, as credentials for an authentication attempt. If accepted, a string
representing an access policy and/or VLAN authorization may be returned. If present, the switch
applies the associated policy rules and VLAN segmentation.
You can specify a mask to apply to MAC addresses when authenticating users through a RADIUS
server (see
significant bit masks is for authentication of all MAC addresses for a specific vendor.

Commands

For information about...

show macauthentication

show macauthentication session
set macauthentication
set macauthentication password
clear macauthentication password
set macauthentication port
set macauthentication portinitialize
set macauthentication portquietperiod
clear macauthentication portquietperiod
set macauthentication macinitialize
set macauthentication reauthentication
set macauthentication portreauthenticate
set macauthentication macreauthenticate
set macauthentication reauthperiod
clear macauthentication reauthperiod
set macauthentication significant-bits
clear macauthentication significant-bits
show macauthentication
Use this command to display MAC authentication information for one or more ports.
Syntax
show macauthentication [port-string]
"set macauthentication significant-bits" on page 32-39). The most common use of
Configuring MAC Authentication
Refer to page...
32-29
32-31
32-32
32-32
32-33
32-33
32-34
32-34
32-35
32-35
32-36
32-36
32-37
32-37
32-38
32-39
32-39
Enterasys C3 Configuration Guide 32-29