Setting The Baseline For Mpls Statistics; Setting A Baseline For Mpls Major Interface Statistics - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide

Setting the Baseline for MPLS Statistics

You can use the baseline mpls commands to set a statistics baseline for MPLS
operations. The router implements the baseline by setting the statistics to zero and
then subtracting this baseline when you retrieve baseline-relative statistics.
Use the delta keyword with the show mpls commands to display baselined statistics.
Tasks to set a baseline for MPLS statistics are:

Setting a Baseline for MPLS Major Interface Statistics

To set a statistics baseline for MPLS major interfaces:
316
Setting the Baseline for MPLS Statistics
Monitoring LDP Targeted Hello Receive and Send Lists on page 337
Monitoring MPLS Status and Configuration on page 338
Monitoring MPLS Explicit Paths on page 341
Monitoring the RSVP-TE Bypass Tunnels on page 341
Monitoring MPLS Labels Used for Forwarding on page 342
Monitoring MPLS Interfaces on page 343
Monitoring MPLS Minor Interfaces on page 349
Monitoring MPLS Next Hops on page 351
Monitoring the Configured Mapping between PHB IDs and Traffic Class/Color
Combinations on page 352
Monitoring RSVP-TE Profiles and MPLS Tunnel Profiles on page 353
Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or
Sessions on page 354
Monitoring RSVP MD5 Authentication on page 358
Monitoring RSVP-TE Interfaces Where BFD is Enabled on page 359
Monitoring RSVP-TE Interface Counters on page 360
Monitoring RSVP-TE Graceful Restart on page 362
Monitoring RSVP-TE Hello Adjacency Instances on page 363
Monitoring Status and Configuration for MPLS Tunnels on page 365
Verifying and Troubleshooting MPLS Connectivity on page 367
Packet Flow Examples for Verifying MPLS Connectivity on page 369
Troubleshooting MTU Problems in Point-to-Point LSPs on page 376
Setting a Baseline for MPLS Major Interface Statistics on page 316
Enabling and Setting a Baseline for MPLS Forwarding Table Statistics on page 317
Enabling and Setting a Baseline for MPLS Next-Hop Table Statistics on page 318
Setting a Baseline for MPLS Tunnel Statistics on page 318
Enabling Statistics Collection for Policies Attached to MPLS Tunnels on page 318