Table 93: Show Subscriber-Policy Output Fields; Monitoring Bgp-Related Settings For Vpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Subscriber: default Trunk
Table 93 on page 631 lists the show subscriber-policy command output fields.
Meaning

Table 93: show subscriber-policy Output Fields

Related Topics

Monitoring BGP-Related Settings for VPLS

You can use the show ip bgp commands listed in Table 94 on page 632 to display
BGP-related settings for VPLS instances in the L2VPN address family or in the VPLS
address family.
Unicast : Permit
PPPoE : Permit
Relearn : Permit
Mpls : Permit
ARP : Permit
Broadcast : Permit
Multicast : Permit
Unknown Destination : Permit
IP : Permit
Unknown Protocol : Permit
Unicast : Permit
PPPoE : Permit
Relearn : Permit
Mpls : Permit
Subscriber: client01
ARP : Permit
Broadcast : Permit
Multicast : Deny
Unknown Destination : Deny
IP : Permit
Unknown Protocol : Permit
Unicast : Permit
PPPoE : Permit
Relearn : Deny
Mpls : Permit
Field Name Field Description
Subscriber Name of the subscriber policy
Permit Indicates that the subscriber interface forwards packets of the
specified type. For the relearn attribute, specifies that relearning a
MAC address entry on a different interface from the one initially
associated with this entry in the forwarding table is allowed on this
interface
Deny Indicates that the subscriber interface filters packets of the specified
type. For the relearn attribute, specifies that relearning is prohibited
on this interface
show subscriber-policy
Chapter 11: Monitoring VPLS
Monitoring BGP-Related Settings for VPLS
631