Figure 134: Topology For Vpws Configuration Example - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
2.
3.
4.
Related Topics
VPWS Configuration Example
The example in this section shows how to configure the VPWS topology illustrated
in Figure 134 on page 666. The example includes procedures for configuring VPWS
on both the local E Series router (PE 1) and the remote E Series router (PE 2).

Figure 134: Topology for VPWS Configuration Example

666
VPWS Configuration Example
Configure the core-facing interface on which you want to enable MPLS, Label
Distribution Protocol (LDP), and topology-driven LSPs.
host1(config)#interface atm 5/0.100
host1(config-subif)#atm pvc 100 1 100 aal5snap 0 0 0
host1(config-subif)#ip address 192.168.5.5 255.255.255.0
Enable MPLS on the core-facing interface.
host1(config-subif)#mpls
Enable LDP and topology-driven LSPs on the core-facing interface.
host1(config-subif)#mpls ldp
host1(config-subif)#exit
Configuring MPLS on page 267
atm pvc
interface atm
ip address
mpls
mpls ldp