Chapter 14
Monitoring VPWS
Clearing BGP Attributes for VPWS
This chapter describes the commands you can use to monitor and troubleshoot
Virtual Private Wire Service (VPWS) L2VPNs on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and
show commands is identical to output from other E Series routers, except that the
E120 and E320 router output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
This chapter contains the following sections:
Clearing BGP Attributes for VPWS on page 671
Monitoring BGP-Related Settings for VPWS L2VPNs on page 673
Monitoring BGP Next Hops for VPWS L2VPNs on page 677
Monitoring VPWS Connections on page 679
Monitoring VPWS Instances on page 681
Monitoring L2VPN Interfaces for VPWS on page 684
Monitoring MPLS Forwarding Table for VPWS on page 686
You can use the following clear ip bgp commands to remove specific BGP attributes
for the L2VPN address family, and in one case, for the VPWS address family.
Tasks to clear BGP attributes are:
"Clearing BGP Reachability Information for the L2VPN Address Family" on
page 672
"Clearing BGP Route Flap Dampening Information for the L2VPN Address Family"
on page 672
"Clearing the Wait for the End-of-RIB Marker for the L2VPN Address Family"
on page 672
Clearing BGP Attributes for VPWS
671