Configuring Explicit Routing For Mpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

When an endpoint is dynamically learned from the specified routing protocol, MPLS
searches its tunnel profiles for a match. The dynamic tunnel is established using the
settings from the first matching profile.
Related Topics

Configuring Explicit Routing for MPLS

When you configure explicit routing rather than hop-by-hop routing for MPLS, the
route the LSP takes is defined by the ingress node. The path consists of a series of
hops defined by the ingress LSR. Each hop can be a traditional interface, an
autonomous system, or an LSP.
MPLS explicit routing configuration tasks include the following sets of tasks:
MPLS Global Configuration Tasks on page 269
MPLS Interface Configuration Tasks on page 274
MPLS Tunnel Configuration Tasks on page 276
MPLS Tunnel Profile Configuration Tasks on page 277
Additional LDP Configuration Tasks on page 281
Additional RSVP-TE Configuration Tasks on page 286
mpls tunnels profile
tunnel destination
tunnel mpls affinity
tunnel mpls autoroute announce
tunnel mpls autoroute metric
tunnel mpls bandwidth
tunnel mpls description
tunnel mpls no-route retries
tunnel mpls no-route retry-time
tunnel mpls path-option
tunnel mpls priority
tunnel mpls retries
tunnel mpls retry-time
Defining Configured Explicit Paths on page 280
Specifying Configured Explicit Paths on a Tunnel on page 280
Configuring Dynamic Explicit Paths on a Tunnel on page 281
Chapter 3: Configuring MPLS
Configuring Explicit Routing for MPLS
279