Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 537

show mpls l2transport load-balancing-group
0 param probs, 0 src qnch, 0 redirect
0 timestamp req, 0 timestamp rpy
0 addr mask req, 0 addr mask rpy
atm4/0.134 is up, line protocol is up
VRF: pe11
Link up/down trap is disabled
Internet address is 4.4.4.2/255.255.255.0
IP statistics:
Rcvd: 0 local destination
0 hdr errors, 0 addr errors
0 unkn proto, 0 discards
Frags: 0 reasm ok, 0 reasm req, 0 reasm fails
0 frag ok, 0 frag creates, 0 frag fails
Sent: 0 generated, 0 no routes, 0 discards
ICMP statistics:
Rcvd: 0 errors, 0 dst unreach, 0 time exceed
0 param probs, 0 src quench, 0 redirect,
0 echo req, 0 echo rpy
0 timestmp req, 0 timestmp rpy
0 addr mask req, 0 addr mask rpy
Sent: 0 errors, 0 dst unreach, 0 time excd
0 param probs, 0 src qnch, 0 redirect
0 timestamp req, 0 timestamp rpy
0 addr mask req, 0 addr mask rpy
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Forwarded Packets 0, Bytes 0
In Total Dropped Packets 0, Bytes 0
In Policed Packets 0
In Invalid Source Address Packets 0
In Error Packets 0
In Discarded Packets 0
In Fabric Dropped Packets 0
Out Forwarded Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
Out Requested Packets 0, Bytes 0
Out Total Dropped Packets 0, Bytes 0
Out Scheduler Drops Committed Packets 0, Bytes 0
Out Scheduler Drops Conformed Packets 0, Bytes 0
Out Scheduler Drops Exceeded
Out Policed Packets 0
Out Discarded Packets 0
Out Fabric Dropped Packets 0
See show ip vrf.
Use to display information about load-balanced Martini circuits.
For a simpler view, the show mpls l2transport interface command displays
only the currently active VLAN or S-VLAN subinterface. Because load-balanced
circuits are configured on subinterfaces on multiple ports, only one of which is
Chapter 5: Configuring BGP-MPLS Applications
Packets 0, Bytes 0
Monitoring BGP/MPLS VPNs
501