Mpls Platform Considerations; Mpls References - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

MPLS Platform Considerations

For information about modules that support MPLS on the ERX7xx models, ERX14xx
models, and the ERX310 Broadband Services Router:
For information about modules that support MPLS on E120 and E320 Broadband
Services Routers:

MPLS References

For more information about the MPLS protocol, consult the following resources:
Admission control and bandwidth enforcement
Tunnels used by IGP as next hops in SPF calculation
Tunnel ingress controlled failure recovery
Facility back-up-style fast-route
Traffic support
Layer 2 frames: ATM, Ethernet, Frame Relay, HDLC, PPP, VLAN
Layer 3 datagrams: IPv4, IPv6
Point-to-multipoint LSP support
Data replication at branch nodes
E Series routers as egress LSRs
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support BGP.
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support MPLS.
JUNOSe Release Notes, Appendix A, System Maximums Refer to the Release Notes
corresponding to your software release for information about maximum values.
Encapsulating MPLS in IP or Generic Routing Encapsulation
(GRE) draft-ietf-mpls-in-ip-or-gre-03.txt (September 2003 expiration)
LDP IGP Synchronization draft-jork-ldp-igp-sync-01.txt (August 2005 expiration)
Detecting Data Plane Failures in Point-to-Multipoint Multiprotocol Label Switching
(MPLS) - Extensions to LSP Ping draft-ietf-mpls-p2mp-lsp-ping-08.txt (February
2010 expiration)
RFC 2104 HMAC: Keyed-Hashing for Message Authentication (February 1997)5.2
Chapter 2: MPLS Overview
MPLS Platform Considerations
207