Table 69: Show Atm Mcpt-Timers Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
To set a statistics baseline for layer 2 services over MPLS:
There is no no version.
Related Topics
Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over MPLS
Display the current systemwide values configured on the router for the three ATM
Purpose
Martini cell packing timers.
The ATM Martini cell packing timers define the time threshold that the router uses
to collect and concatenate ATM cells in a single VCC cell relay–encapsulated packet.
To display ATM Martini cell packing timers:
Action
host1(config)#show atm mcpt-timers
ATM Martini cell aggregation timers:
Table 69 on page 564 lists the show atm mcpt-timers command output fields
Meaning

Table 69: show atm mcpt-timers Output Fields

Related Topics
Monitoring ATM Subinterfaces for Layer 2 Services over MPLS
Display the current state of all specified ATM subinterfaces.
Purpose
564
Monitoring ATM Martini Cell Packing Timers for Layer 2 Services over MPLS
Issue the baseline mpls interface command:
host1#baseline mpls interface
baseline mpls interface
Timer1: 1500microseconds
Timer2: 2500microseconds
Timer3: 3500microseconds
Field Name Field Description
Timer1 Value in microseconds for the first ATM Martini cell packing timer
Timer2 Value in microseconds for the second ATM Martini cell packing
timer
Timer3 Value in microseconds for the third ATM Martini cell packing timer
show atm mcpt-timers