Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 586

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Configuration on CE2 (Remote CE Router)
Use the following commands on the remote CE router (CE2) to configure the MPLS
L2VPN tunnel shown inFigure 122 on page 548.
550
MPLS L2VPN Tunnel over VLAN over LAG Configuration Example
host1:pe2(config)#mpls .
!
! Configure PE2 to create topology-driven LSPs. Enabling LDP automatically creates
! topology-driven LSPs.
host1:pe2(config)#mpls topology-driven-lsp
!
! On PE2, configure a loopback interface, and assign an IP address and mask to
! the interface.
host1:pe2(config)#interface loopback 0
host1:pe2(config-if)#ip address 22.22.22.22 255.255.255.255
!
! Assign the router ID using the IP address you configured for the loopback
! interface.
host1:pe1(config)#ip router-id 22.22.22.22
!
! Create a Gigabit Ethernet interface and configure MPLS tunneling with the IP
! address of the router on the remote end of the layer 2 circuit and the virtual
! circuit identifier.
host1:pe2(config)#interface gigabitEthernet 2/1/6
host1:pe2(config-if)#encapsulation vlan
!
! Create a VLAN subinterface by adding a subinterface number to the interface
! identification command. Assign an S-VLAN ID and a VLAN ID for the subinterface.
! Also, configure MPLS tunneling.
host1:pe2(config-if)#interface gigabitEthernet 2/1/6.1
host1:pe2(config-subif)#svlan id 1 1
host1:pe2(config-subif)#mpls-relay 11.11.11.11 1
!
! Create a Gigabit Ethernet interface on PE2 and specify VLAN as the
! encapsulation method.
host1:pe2(config)#interface gigabitEthernet 2/1/5
host1:pe2(config-if)#encapsulation vlan
!
! Create another Gigabit Ethernet subinterface on the main interface. For this
! interface, assign a VLAN ID, specify the encapsulation method as VLAN, configure
! MPLS, and assign an IP address and mask. Also, enable LDP and topology-driven
! LSP, as does any LDP-related command, using an implicit default profile, on this
! Gigabit Ethernet subinterface.
host1:pe2(config-if)#interface gigabitEthernet 2/1/5.1
host1:pe2(config-subif)#vlan id 20
host1:pe2(config-subif)#ip address 2.0.0.2 255.255.255.0
host1:pe2(config-subif)#mpls
host1:pe2(config-subif)#mpls ldp
!
! Configure a static route with the destination IP address, mask, and IP address of
! the next hop that can be used to reach the destination network.
host1:pe2(config)#ip route 22.22.22.22 255.255.255.255 2.0.0.1
!
! Configure LDP to advertise a non-null label for the egress routes.
host1:pe2(config)#mpls ldp egress-label non-null