Table 99: Show Vpls Connections Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
-------------------------
ATM2/0.12
vpls vpls2
Connections status code:
UP = Operational
SC = Local and Remote Site Identifier Collision
EM = Encapsulation Mismatch
OR = Out of Range
DN = VC Down because Remote PE Unreachable
LD = Local Site Down
RD = Remote Site Down
AS = Max BGP AS path length exceeded
OL = No Out Label
Site
-----
2
Table 99 on page 640 lists the show vpls connections command output fields.
Meaning

Table 99: show vpls connections Output Fields

640
Monitoring VPLS-Specific Settings
Learning:
Max Learn:
Link Status Snmp Traps: Disabled
Subscriber Policy:
Port Count:
Interface Count:
Transport Virtual Rtr:
Route Distinguisher:
SiteName:
SiteId:
SiteRange:
VPLS Route Targets
Route Target: RT:100:2 (both)
Flood Next Hop: Index 1048578
MPLS next-hop: 21, label 56, resolved by MPLS next-hop 19
MPLS next-hop: 19, resolved by MPLS next-hop 17, peer 2.2.2.2
MPLS next-hop: 17, label 82 on ATM2/0.10, nbr 10.10.10.2
Interface
State Remote PE
----- ---------------
UP 2.2.2.2
Field Name Field Description
BridgeGroup Name of the VPLS instance for which information is displayed
Bridge Mode Bridging capability currently enabled; for a VPLS instance, this field
always displays default
Aging Time Length of time, in seconds, that a MAC address entry can remain
in the forwarding table before expiring
Learning Whether acquisition of dynamically learned MAC addresses is
enabled or disabled
Max Learn Maximum number of dynamic MAC addresses that the VPLS
instance can learn
Link Status Snmp Traps Whether SNMP link status processing is enabled or disabled
Subscriber Policy Name of the subscriber policy currently in effect
Enabled
Unlimited
default Subscriber
2
1
pe1
1.1.1.1:10
westford
1
20
Port Status
------ ------------
1 Up
2 Up
In-label Out-label MPLS NH Idx
-------- --------- -----------
27 56 21
Up-down Time
------------
00:02:56