Monitoring Rsvp-Te Interfaces Where Bfd Is Enabled; Table 56: Show Mpls Rsvp Bfd Interfaces Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 55: show mpls rsvp authentication Output Fields (continued)
Related Topics

Monitoring RSVP-TE Interfaces Where BFD is Enabled

Display information about RSVP-TE major interfaces on which BFD is enabled.
Purpose
For point-to-point interfaces, this command displays a single secure association with
the single peer at the remote end. For multiaccess type interfaces (Ethernet), this
command displays, if present, multiple secure associations from the various RSVP
speakers.
To display information about RSVP-TE major interfaces on which BFD is enabled:
Action
host1#show mpls rsvp bfd interfaces
Interface
---------
ATM2/0.1
Table 56 on page 359 lists the show mpls rsvp bfd interfaces command output fields.
Meaning

Table 56: show mpls rsvp bfd interfaces Output Fields

Field Name Field Description
Receive Sequence Number Sequence number of first authenticated packet from peer;
subsequent packets from the peer must be greater than this base
number
show mpls rsvp authentication
Bfd Enabled RSVP interfaces
---------------------------
Minimum Minimum
Interval Rx-Interval
-------- -----------
300 300
Field Name Field Description
Interface RSVP-TE major interface on which BFD is enabled
Minimum Interval Minimum interval in milliseconds, used when the minimum receive
interval and minimum transmit intervals have the same value
Minimum Rx-Interval Minimum receive interval in milliseconds; minimum interval at
which the local peer must receive BFD control packets from the
remote peer
Minimum Tx-Interval Minimum transmit interval in milliseconds; interval at which the
local peer proposes to transmit BFD control packets to the remote
peer
Minimum
Tx-Interval Multiplier
----------- ----------
300 3
Monitoring RSVP-TE Interfaces Where BFD is Enabled
Chapter 4: Monitoring MPLS
359