Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 567

2.
3.
Related Topics
Configuring Ethernet/VLAN Layer 2 Services
To configure Ethernet/VLAN layer 2 services over MPLS:
1.
2.
3.
Related Topics
host1(config-if)#interface serial 4/1:1/1.1
host1(config-subif)#frame-relay interface-dlci 17 ietf
Specify MPLS tunneling by using the appropriate command.
host1(config-if)#mpls-relay 10.10.100.2 45 relay-format frame-relay
or
host1(config-if)#route interface tunnel mpls:tunnel6 45 relay-format frame-relay
Configure Frame Relay and MPLS on the remote PE router.
For information about configuring a more complex Frame Relay over MPLS
topology, see Frame Relay over MPLS Configuration Example on page 544
encapsulation frame-relay ietf
frame-relay interface-dlci ietf
frame-relay intf-type
frame-relay lmi-type
interface serial
mpls-relay
route interface
Configure the Ethernet/VLAN interface.
host1(config)#interface fastEthernet 4/0
host1(config-if)#encapsulation vlan
host1(config-if)#interface fastEthernet 4/0.3
host1(confi-if)#vlan id 201
Specify MPLS tunneling by using the appropriate command.
host1(config-if)#mpls-relay 10.10.100.2 45
or
host1(config-if)#route interface tunnel mpls:tunnel6 45
Configure Ethernet/VLAN and MPLS on the remote PE router.
encapsulation vlan
interface fastEthernet
Chapter 7: Configuring Layer 2 Services over MPLS
Configuring Ethernet/VLAN Layer 2 Services
531