Table 101: Commands To Configure Basic Vpws Instances - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

6.
Related Topics
Configuring a VPWS Instance
You must configure a VPWS instance for each L2VPN in which the router participates.
From a configuration standpoint, a VPWS instance is simply a new L2VPN that you
configure with additional VPWS L2VPN attributes.
Table 101 on page 659 lists the commands that you use to configure a basic VPWS
instance.

Table 101: Commands to Configure Basic VPWS Instances

To configure a basic VPWS instance on the PE router:
d. Activate the neighbors in the L2VPN address family for the PE-to-PE BGP
session.
e. Create the VPWS address family to configure the router to exchange layer
2 NLRI for each VPWS instance configured on the router.
Configure MPLS label-switched paths (LSPs) to connect the local and remote PE
routers.
a. Enable MPLS on the virtual router.
b. Configure the core-facing interface on which you want to enable MPLS, Label
Distribution Protocol (LDP), and topology-driven LSPs.
c. Enable MPLS on the core-facing interface.
d. Enable LDP and topology-driven LSPs on the core-facing interface.
Configuring BGP Signaling for VPWS on page 664
Configuring a Local Cross-Connect for VPWS on page 662
Configuring a VPWS Instance on page 659
Configuring Customer-Facing Interfaces in the VPWS Instance on page 661
Configuring the Loopback Interface and Router ID for BGP for VPWS on page 663
Configuring MPLS LSPs for VPWS on page 665
For a detailed sample configuration, see VPWS Configuration Example on page 666
l2vpn control-word
l2vpn encapsulation-type
l2vpn local-site-id remote-site-id
l2vpn rd
Chapter 13: Configuring VPWS
l2vpn route-target
l2vpn sequencing
l2vpn site-name site-id
l2vpn site-range
Configuring a VPWS Instance
659