Monitoring Mpls Status And Configuration; Table 44: Show Ldp Targeted Session Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Table 44 on page 338 lists the show ldp targeted session command output fields.
Meaning

Table 44: show ldp targeted session Output Fields

Related Topics

Monitoring MPLS Status and Configuration

Display status and configuration information about MPLS.
Purpose
To display information about MPLS Status and configuration:
Action
host1#show mpls
MPLS administratively enabled
Loop Detect enabled
Additional detail is shown when LDP is enabled:
LDP
338
Monitoring MPLS Status and Configuration
Targeted session sent to 10.9.1.3 is up
indirect nexthop index 3, resolved
Targeted session sent to 10.9.1.6 is up
indirect nexthop index 206, resolved
Field Name Field Description
D Targeted session created by layer 2 over MPLS connection; see
Layer 2 Services over MPLS Overview in the JUNOSe BGP and MPLS
Configuration Guide for more information about layer 2 over MPLS
S Targeted session statically created by user
A Targeted session created by access list
Used By Letter representing source of targeted session
show ldp targeted session
Current state is Config incomplete
LSR ID is 10.2.2.2
Re-optimization timer is 3600
Label range 3000 ~ 4000
retry forever at interval 30 during LSP setup if there is route
retry forever at interval 30 during LSP setup if there is no route
LSR ID is 80.0.0.2
FEC Deaggregation is off
Egress label: implicit-null
Label distribution control mode: ordered control
LDP session retry 0 times at interval 10
LDP session hold time: 180
LDP session keepalive interval: 20
LDP targeted-hello hold time: 45
LDP targeted-hello interval: 15
Used By: D
Used By: S