Layer 2 Services Over Mpls Implementation - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org for the latest drafts.
For information about configuring supported layer 2 interfaces, consult the following
resources:
For information about configuring supported serial interfaces, which are also referred
to as HDLC channels, see the following resources:
For information about configuring MPLS, see "Configuring MPLS" on page 267.

Layer 2 Services over MPLS Implementation

When layer 2 services are configured over MPLS, layer 2 traffic is encapsulated in
MPLS frames and sent over MPLS tunnels. A virtual circuit (VC) label that indicates
a specific layer 2 connection, such as a Frame Relay data-link connection identifier
(DLCI), is pushed into the label stack between the tunnel label and the layer 2 data.
512
Layer 2 Services over MPLS Implementation
Encapsulation Methods for Transport of PPP/HDLC Over IP and MPLS
Networks draft-ietf-pwe3-hdlc-ppp-encap-mpls-03.txt (October 2004 expiration)
Framework for Pseudo Wire Emulation Edge-to-Edge
(PWE3) draft-ietf-pwe3-arch-06.txt (April 2004 expiration)
IEEE 802.3ad (Link Aggregation)
Pseudowire Setup and Maintenance Using
LDP draft-ietf-pwe3-control-protocol-08.txt (January 2005 expiration)
Requirements for Pseudo-Wire Emulation Edge-to-Edge
(PWE3) draft-ietf-pwe3-requirements-08.txt (June 2004 expiration)
Transport of Layer 2 Frames Over MPLS draft-martini-12circuit-trans-mpls-11.txt
(October 2003 expiration)
JUNOSe Physical Layer Configuration Guide
See Configuring ATM in JUNOSe Link Layer Configuration Guide.
See Configuring Frame Relay in JUNOSe Link Layer Configuration Guide.
See Configuring Packet over SONET in JUNOSe Link Layer Configuration Guide.
See Configuring Bridged Ethernet in JUNOSe Link Layer Configuration Guide.
See Configuring Channelized T3 Interfaces in JUNOSe Physical Layer Configuration
Guide.
See Configuring T3 and E3 in JUNOSe Physical Layer Configuration Guide.
See Configuring Channelized OCx/STMx Interfaces in JUNOSe Physical Layer
Configuration Guide.