Table 72: Show Mpls Forwarding Output Fields; Monitoring Mpls Layer 2 Interfaces For Layer 2 Services Over Mpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide

Table 72: show mpls forwarding Output Fields

Related Topics

Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS

Display status and configuration information about MPLS layer 2 major, minor, and
Purpose
shim interfaces. Both the show mpls interface shim command and the show mpls
l2transport interface command provide the same output. The shim keyword displays
all shim interfaces. The brief keyword displays only limited interface information.
To display information about MPLS layer 2 interfaces:
Action
host1#show mpls interface shim
MPLS shim interface FastEthernet2/0
568
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS
Field Name Field Description
name/id Interface specifier
destination Destination IP address
In label Label sent to upstream neighbor for route
Out label Label received from downstream neighbor for route
pkts Number of packets sent across tunnel
hcPkts Number of high-capacity (64-bit) packets sent across tunnel
octets Number of octets sent across tunnel
hcOctets Number of high-capacity (64-bit) octets sent across tunnel
errors Number of packets dropped for some reason before being sent
discardPkts Number of packets discarded due to lack of buffer space before
being sent
show mpls forwarding
Remote PE address is 10.9.1.3
Virtual circuit ID is 1
Group ID is 0 by default
Control word is not preferred by default
Don't send sequence numbers by default
Relay format is ethernet by default
ATM VPI/VCI range is 1-2/100-109 (up on the line card)
ATM VPI/VCI range is 5-10/200-300 (up on the line card)
ATM cell aggregation is enabled
ATM cell aggregation maximum cells per packet is 20
ATM cell aggregation timeout timerId is 2
Administrative state is enabled
Operational state is down (shim interface does not have a next-hop)
Operational MTU is 1500