Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 20

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Chapter 7
xx
Table of Contents
VCC Cell Relay Encapsulation ...............................................................518
AAL0 Raw Cell Mode ......................................................................518
Cell Concatenation Parameters .......................................................518
Cell Concatenation and Latency .....................................................518
Control Word Support ....................................................................519
Unsupported Features ....................................................................519
HDLC Layer 2 Services over MPLS ...............................................................519
Interface Stacking .................................................................................520
Encapsulation .......................................................................................520
Control Word Support ...........................................................................520
Local Cross-Connects ............................................................................520
CE-Side MPLS L2VPNs over LAG Overview ..................................................521
Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport
Overview ..............................................................................................522
S-VLAN Subinterface with an Untagged C-VLAN ID Overview ......................524
Multiple ATM Virtual Circuits over a Single Pseudowire Overview ...............524
Guidelines for Configuring VPI/VCI Ranges of ATM Virtual Circuits .......527
Guidelines for Configuring Cell Concatenation and Cell Packing Timer
for an ATM Port ..............................................................................528
Performance Impact and Scalability Considerations .............................528
Configuring Layer 2 Services over MPLS
Before You Configure Layer 2 Services over MPLS ......................................529
Configuring Frame Relay Layer 2 Services ..................................................530
Configuring Interoperation with Legacy Frame Relay Layer 2 Services ........530
Configuring Ethernet/VLAN Layer 2 Services ...............................................531
Configuring S-VLAN Tunnels for Layer 2 Services ........................................532
Configuring Local Cross-Connects Between Ethernet/VLAN Interfaces .........533
Configuring Local ATM Cross-Connects with AAL5 Encapsulation ...............534
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation .........536
Configuring HDLC Layer 2 Services .............................................................538
Configuring Local Cross-Connects for HDLC Layer 2 Services ...............539
Configuring CE-Side Load Balancing for Martini Layer 2 Transport ..............540
Configuring Many Shim Interfaces with the Same Peer, VC Type, and
VC ID ..............................................................................................540
Configuring Load-Balancing Groups ......................................................542
MPLS Interfaces and Labels ............................................................543
Configuring Load-Balancing Groups ................................................543
Adding a Member Interface to a Group Circuit ...............................543
Removing Member Subinterfaces from a Circuit ............................543
Frame Relay over MPLS Configuration Example ..........................................544
MPLS L2VPN Tunnel over VLAN over LAG Configuration Example ..............547
Configuration on CE1 (Local CE Router) ................................................548
Configuration on PE1 (Local PE Router) ................................................548
Configuration on PE2 (Remote PE Router) ............................................549
Configuration on CE2 (Remote CE Router) ............................................550
MPLS L2VPN Tunnel over LAG Configuration Example ................................551
Configuration on CE1 (Local CE Router) ................................................552
Configuration on PE1 (Local PE Router) ................................................552
529