Table 82: Commands To Configure Ldp Signaling For Vpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Related Topics
Configuring LDP Signaling for VPLS
LDP signaling establishes targeted sessions to the remote VEs configured at the edge
of the service provider's MPLS core network. To enable LDP to establish these targeted
sessions, you issue the mpls ldp vpls-id command to configure a VPLS identifier for
the VPLS instance, and the mpls ldp vpls neighbor command to configure a list of
neighbor (peer) addresses to which LDP can send or from which LDP can receive
targeted hello messages.
This section describes how to configure LDP signaling for a VPLS network, but does
not provide complete details about configuring LDP on E Series routers.
Table 82 on page 607 lists the commands discussed in this section to configure LDP
signaling for VPLS.

Table 82: Commands to Configure LDP Signaling for VPLS

To configure LDP signaling for VPLS on the PE router:
1.
2.
3.
Related Topics
Configuration Tasks for VPLS with LDP Signaling on page 605
bridge vpls transport-virtual-router
mpls ldp vpls neighbor
Configure the VPLS identifier, which is a globally unique identifier for each VPLS
domain.
host1(config)#mpls ldp vpls customer3 vpls-id 3
Enable LDP signaling for a VPLS instance by configuring a list of neighbor (peer)
addresses on remote VE devices in the VPLS domain to which LDP can send or
from which LDP can receive targeted hello messages.
host1(config)#mpls ldp vpls customer3 neighbor 10.3.3.3
host1(config)#mpls ldp vpls customer3 neighbor 10.3.10.100
Repeat these steps for each VPLs instance on the PE router.
Configuration Tasks for VPLS with LDP Signaling on page 605
For more information about LDP, see Configuring MPLS on page 267 .
mpls ldp vpls neighbor
mpls ldp vpls vpls-id
Chapter 10: Configuring VPLS
mpls ldp vpls vpls-id
Configuring LDP Signaling for VPLS
607