Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 646

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Configuration on PE 2 (Remote PE Router)
Use the following commands on the remote PE router (PE 2) to configure the VPLS
topology shown in Figure 130 on page 609.
610
VPLS Configuration Example with LDP Signaling
host1(config)#bridge vplsA vpls transport-virtual-router default
!
! Configure VPLS instance vplsB.
host1(config)#bridge vplsB vpls transport-virtual-router default
!
! Configure Fast Ethernet interface 2/1 between PE 1 and CE 1,
! and assign it to vplsA as a trunk interface.
host1(config)#interface fastEthernet 2/1
host1(config-if)#bridge-group vplsA subscriber-trunk
host1(config-if)#exit
!
! Configure bridged Ethernet interface 6/0.12 between PE 1 and CE 2,
! and assign it to vplsB as a trunk interface.
host1(config)#interface atm 6/0.12 point-to-point
host1(config-subif)#atm pvc 12 0 12 aal5snap 0 0 0
host1(config-subif)#encapsulation bridge1483 mac-address 0090.1a40.9991
host1(config-subif)#bridge-group vplsB subscriber-trunk
host1(config-if)#exit
!
! Configure LDP signaling for vplsA.
host1(config)#mpls ldp vpls vplsA vpls-id 1
host1(config)#mpls ldp vpls vplsA neighbor 2.2.2.2
! Configure LDP signaling for vplsB.
host1(config)#mpls ldp vpls vplsB vpls-id 2
host1(config)#mpls ldp vpls vplsB neighbor 2.2.2.2
!
! Configure a loopback interface on PE 1 and assign it an IP address.
host1(config)#interface loopback 0
host1(config-if)#ip address 1.1.1.1 255.255.255.255
host1(config-if)#exit
!
! Assign the router ID for PE 1 using the IP address of the loopback interface.
host1(config)#ip router-id 1.1.1.1
!
! Configure ATM core-facing interface 6/0.10 between PE 1 and the P router,
! and assign it an IP address.
host1(config)#interface atm 6/0.10 point-to-point
host1(config-subif)#atm pvc 10 0 10 aal5snap 0 0 0
host1(config-subif)#ip address 10.10.10.1 255.255.255.0
!
! Enable MPLS, LDP, and topology-driven LSPs on the core-facing interface.
host1(config-subif)#mpls
host1(config-subif)#mpls ldp
host1(config-subif)#exit
!
! Configure OSPF routing in the core MPLS network.
host1(config)#router ospf 1
host1(config-router)#network 1.1.1.1 0.0.0.0 area 0.0.0.0
host1(config-router)#network 10.10.10.0 0.0.0.255 area 0.0.0.0
host1(config-router)#exit