Monitoring Mpls; Chapter 4 Monitoring Mpls - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Chapter 4

Monitoring MPLS

This chapter describes the commands you can use to monitor and troubleshoot
Multiprotocol Label Switching (MPLS) on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and
show commands is identical to output from other E Series routers, except that the
E120 and E320 router output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
This chapter contains the following sections:
Setting the Baseline for MPLS Statistics on page 316
Clearing and Re-Creating Dynamic Interfaces from MPLS Major
Interfaces on page 319
Clearing and Refreshing IPv4 Dynamic Routes in the Tunnel Routing
Table on page 319
Clearing and Refreshing IPv6 Dynamic Routes in the Tunnel Routing
Table on page 319
Tracing Paths Through the MPLS User Plane on page 320
Monitoring ATM VCs and VPI/VCI Ranges Used for MPLS on page 320
Monitoring Global Call Admission Control Configuration on page 322
Monitoring Interfaces Configured with Traffic Engineering Bandwidth
Accounting on page 322
Monitoring Virtual Router Configuration on page 323
Monitoring IP and IPv6 Tunnel Routing Tables on page 323
Monitoring LDP on page 325
Monitoring MPLS Label Bindings on page 327
Monitoring LDP Graceful Restart on page 328
Monitoring Interfaces That are Synchronizing with LDP on page 329
Monitoring LDP Interfaces on page 330
Monitoring LDP Neighbors on page 332
Monitoring LDP Profiles on page 334
Monitoring LDP Statistics on page 335
315