Clearing And Re-Creating Dynamic Interfaces From Mpls Major Interfaces; Table; Clearing And Refreshing Ipv6 Dynamic Routes In The Tunnel Routing Table - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Statistics are not stored in NVS. When enabled, the following statistics are maintained
for each policy:
To disable collection of policy statistics for a specific MPLS tunnel:

Clearing and Re-Creating Dynamic Interfaces from MPLS Major Interfaces

To remove and re-create dynamic IPv4 interfaces and dynamic IPv6 interfaces from
all MPLS major interfaces or a specific MPLS major interface:
You can use this command to reapply policies related to dynamic IPv4 and IPv6
interfaces on top of MPLS major interfaces.
There is no no version.
Related Topics
Clearing and Refreshing IPv4 Dynamic Routes in the Tunnel Routing Table
To clear and then refresh a specified IPv4 dynamic route or all IPv4 dynamic routes
from the tunnel routing table of the virtual router or a specified VRF:
There is no no version. This command takes effect immediately.
Related Topics

Clearing and Refreshing IPv6 Dynamic Routes in the Tunnel Routing Table

To clear and then refresh a specified IPv6 dynamic route or all IPv6 dynamic routes
from the tunnel routing table of the virtual router or a specified VRF.
packets and bytes
Issue the no mpls statistics policy command.
host1#no mpls statistics policy tunnel5
Issue the clear mpls dynamic-interfaces on-major-interfaces command:
host1#clear mpls dynamic-interfaces on-major-interfaces
clear mpls dynamic-interfaces on-major-interfaces
Issue the clear ip tunnel-routes command.
host1(config)#clear ip tunnel-routes *
clear ip tunnel-routes
Clearing and Re-Creating Dynamic Interfaces from MPLS Major Interfaces
classifier group
Chapter 4: Monitoring MPLS
EXP bits value
319