Table 70: Show Atm Subinterface Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

To display the current state of all ATM subinterfaces:
Action
host1#show atm subinterface
Interface ATM-Prot VCD VPI VCI Type Encap MTU
----------- -------- --- --- --- ---- ----- ---- ------ -------
ATM 2/0.100 ATM/MPLS 100
ATM 2/0.101 ATM/MPLS 101
ATM 2/0.200 RFC-1483 200
ATM 2/0.201 RFC-1483 201
4 interface(s) found
To display the current state of a specific ATM subinterface:
host1#show atm subinterface atm 2/0.100
Interface ATM-Prot VCD VPI VCI
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 2/0.100 ATM/MPLS 100
Maximum number of cells per packet: 100
Cell aggregation timeout timer:
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Table 70 on page 565 lists the show atm subinterface command output fields; for a
Meaning
description of the other fields in this display, see Monitoring ATM in the JUNOSe Link
Layer Configuration Guide.

Table 70: show atm subinterface Output Fields

Field Name
Encap
Maximum number of cells
per packet
Cell aggregation timeout
timer
Chapter 8: Monitoring Layer 2 Services over MPLS
0 100 PVC AAL0 9180 up
0 101 PVC AAL5 9180 up
0 200 PVC SNAP 9180 up
0 201 PVC SNAP 9180 up
Circuit
Type Encap MTU
0 100 PVC AAL0
2
0
0
0
0
0
0
0
0
Field Description
Encapsulation type:
AAL0 VCC cell relay–encapsulated circuits that receive raw
ATM cells
AAL5 ATM cross-connect interfaces
Maximum number of ATM cells that the router can concatenate in
a single packet; if this value is not configured, " Martini cell
aggregation: disabled" appears instead of this field. Displayed for
an individual ATM over MPLS interface with AAL0 encapsulation
Identifier (1, 2, or 3) of the ATM Martini cell packing timer that
detects timeout of the cell collection threshold; if this value is not
configured, " Martini cell aggregation: disabled" appears instead
of this field. Displayed for an individual ATM over MPLS interface
with AAL0 encapsulation
Monitoring ATM Subinterfaces for Layer 2 Services over MPLS
Status Address
--
--
--
--
Interface
Status Type
9180 lowerLayerDown Static
565