Table 7: Commands Affecting The Current Address Family; Table 8: Commands Affecting All Address Families For The Specified Peer Or; Peer Group - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

The commands listed in Table 7 on page 19 configure parameters only for the
current address family context.

Table 7: Commands Affecting the Current Address Family

address family
aggregate-address
auto-summary
bgp dampening
bgp wait-on-end-of-rib
check-vpn-next-hops
default-information originate
The commands listed in Table 8 on page 19 configure parameters for a peer or
peer group, regardless of address family. If the peer or peer group is activated
in more than one address family, the values are changed in all those address
families. These commands are said to apply on a per-VRF basis. In the following
example, EBGP multihop is configured for the session, but when you configure
an address family, it is not available that is, EBGP multihop is not configurable
per address family:
host1(config-router)#neighbor 10.1.3.4 remote-as 1234
host1(config-router)#neighbor 10.2.3.4 ebgp-multihop 5
host1(config-router)#address-family ipv4 multicast
host1(config-router-af)#neighbor 10.2.3.4 ebgp-multihop ?
% Invalid input detected at '^' marker.
host1(config-router-af)#exit-address-family
Table 8: Commands Affecting All Address Families for the Specified Peer or Peer
Group
neighbor advertisement-interval
neighbor allow
neighbor bfd-liveness-detection
neighbor capability
neighbor description
neighbor ebgp-multihop
neighbor graceful-restart
neighbor graceful-restart restart-time
neighbor graceful-restart stalepaths-time
Chapter 1: Configuring BGP Routing
disable-dynamic-redistribute
external-paths
ip route-type
maximum-paths
network
redistribute
table-map
neighbor maximum-update-size
neighbor passive
neighbor password
neighbor peer-type
neighbor remote-as
neighbor rib-out disable
neighbor shutdown
neighbor site-of-origin
neighbor timers
Basic Configuration
19