Monitoring Ldp Neighbors - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Table 40: show ldp interface Output Fields (continued)
Related Topics

Monitoring LDP Neighbors

Display LDP neighbor information.
Purpose
To display information about LDP neighbor 10.3.5.1:
Action
host1#show ldp neighbor 10.3.5.1
LDP Neighbor: 10.0.2.2
To display brief information about all LDP neighbors:
host1#show ldp neighbor brief
Neighbor
10.0.2.2
To display information about graceful restart for neighbors:
host1#show ldp neighbor graceful-restart
LDP Neighbor: 10.0.1.1
332
Monitoring LDP Neighbors
Field Name Field Description
bad hello recv Number of hello messages received bad
adj setup time Time in hh:mm:ss since adjacency set up
last hello recv time Time in hh:mm:ss since last hello message received
last hello sent time Time in hh:mm:ss since last hello message sent
remaining hold time Time in hh:mm:ss remaining of the hold time
IP-Address IP address of the interface
Protocol Administrative state of LDP, enabled or disabled
show ldp interface
LSR: Remote 10.0.2.2:0, local 10.0.1.1:0
Transport address: remote 10.0.2.2, local 10.0.1.1
State: Operational
LDP advertisement: Unsolicited
Up for 00:20:03
Number of next-hop addresses received = 3
10.0.2.2 100.6.12.2
Number of adjacencies = 1
Link Hello adjacency: address 10.6.12.2, transport 10.0.2.2,
Up for 00:20:09, remaining hold time: 11 sec
Transport Address
10.0.1.1->80.0.2.2
Graceful Restart is disabled
Helper Mode is enabled
Reconnect Time: 0 msec
100.6.23.2
State
Operational