Monitoring Interfaces That Are Synchronizing With Ldp; Table 39: Show Ldp Igp-Sync Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

Table 38: show ldp graceful restart Output Fields (continued)
Related Topics

Monitoring Interfaces That are Synchronizing with LDP

Display information about interfaces that are synchronizing with LDP or the specified
Purpose
interface that is synchronizing with LDP.
To display information about interfaces synchornizing with LDP:
Action
host1#show ldp igp-sync
Atm 0/0:
Table 39 on page 329 lists the show ldp igp-sync command output fields.
Meaning

Table 39: show ldp igp-sync Output Fields

Field Name Field Description
Reconnect Time Locally configured value for reconnect time, in seconds
Recovery Time Locally configured value for recovery time, in seconds
Max Recovery Time Locally configured value for max-recovery timer, in seconds
Neighbor Liveness Timer Locally configured value for neighbor-liveness timer, in seconds
Peer Address, state, and LDP graceful restart state for neighbor
show ldp graceful-restart
LDP configured; SYNC enabled.
SYNC status: sync achieved; peer reachable.
IGP holddown time: infinite.
Peer LDP Ident: 10.130.0.1:0
IGP enabled: OSPF 1
Field Name Field Description
LDP State of LDP, configured, auto-configured, or not configured
SYNC status State of synchronization, enabled or disabled
IGP holddown time Value of IGP hold down time, infinite or number of milliseconds
Peer LDP Ident IP address of LDP peer
IGP enabled IGP protocol
Monitoring Interfaces That are Synchronizing with LDP
Chapter 4: Monitoring MPLS
329