Monitoring Ldp Interfaces; Table 40: Show Ldp Interface Output Fields - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
Related Topics

Monitoring LDP Interfaces

Display information about all LDP interfaces or the specified LDP interface.
Purpose
To display information about all LDP interfaces:
Action
host1#show ldp interface
Interface ATM6/0.120
To display brief information about LDP interfaces:
host1#show ldp interface brief
Interface
ATM6/1.1
ATM6/1.3
ATM6/1.5
ATM6/0.7
ATM6/0.8
ATM6/0.9
NOTE: The mpls keyword is optional and is provided for compatibility with non–E
Series implementations.
Table 40 on page 330 lists the show ldp interface command output fields.
Meaning

Table 40: show ldp interface Output Fields

330
Monitoring LDP Interfaces
show ldp igp-sync
Interface address: 192.168.12.1/28
Enabled with profile 'default'
Configured hold time: 15
Hello interval: 5
Hold Time: 1
242 hello received, 242 hello sent, 0 hello rejected
1 adjacency created, 0 adjacency deleted,
Number of adjacencies = 1
Link hello adjacency: Address: 10.10.12.2, Transport address: 80.0.2.2,
Up for 00:20:09, Remaining hold time: 11 sec
IP-Address
192.168.100.21/30
192.168.100.17/30
192.168.100.13/30
172.16.100.1/30
172.16.100.22/30
172.16.100.14/30
Field Name Field Description
Interface Identifier of the interface
autoconfigured LDP has been autoconfigured on the interface
Interface address IP address of the interface, with address mask
Enabled with profile Name of profile with which interface was enabled
Protocol
enabled
enabled
enabled
enabled
enabled
enabled