Configuring Hdlc Layer 2 Services - Juniper BGP - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x BGP and MPLS Configuration Guide
OutDiscards:
1 interface(s) found
host2#show atm subinterface atm 4/0.101
Interface ATM-Prot VCD VPI VCI
--------- -------- --- --- --- ------- ----- ---- -------------- ---------
ATM 4/0.101 ATM/MPLS 101
Maximum number of cells per packet: 150
Cell aggregation timeout timer:
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Related Topics

Configuring HDLC Layer 2 Services

The following commands configure an HDLC layer 2 circuit over MPLS between an
E Series router and a remote PE device.
To configure an HDLC layer 2 circuit over MPLS:
1.
538
Configuring HDLC Layer 2 Services
0
Circuit
Type Encap MTU
0 101 PVC AAL0 9180 lowerLayerDown Static
3
0
0
0
0
0
0
0
0
atm cell-packing
atm mcpt-timers
atm pvc
interface atm
interface loopback
ip address
mpls-relay
show atm mcpt-timers
show atm subinterface
Configure a serial or POS interface on the ingress router.
host1(config)#interface serial 3/1:2/1
or
host1(config)#interface pos 4/0
Interface
Status Type